engineering economics, Civil Engineering

Ask quA contractor has both a 3-cy and a 5-cy shovel in the equipment fleet. Select the minimum size shovel that will excavate 450,000 bcy of common earth in a minimum of 120 working days of 10 hr each. The average height of excavation will be 18 ft, and the average angle of swing will be 80 degrees. The 3-cy shovel has a maximum digging height of 30 ft and the 5-cy machine;s maximum digging height is 34 ft. The efficiency factor will be a 50-min hour. Appropriate-size units can be used with either shovel. How many days will it require to complete the work? (5-cy machine, 105 days to complete
estion #Minimum 100 words accepted#
Posted Date: 7/11/2019 2:31:01 AM | Location : Ethiopia







Related Discussions:- engineering economics, Assignment Help, Ask Question on engineering economics, Get Answer, Expert's Help, engineering economics Discussions

Write discussion on engineering economics
Your posts are moderated
Related Questions
what is sieve analysis? expalin its procedure.

What are the physical classification of stones

Question While designing sewer pipes , why vitrified clay pipes commonly is used for pipe size less than 600mm still as precast concrete pipes with PVC lining is used for pipe

Analytical Methods for Pollutants Regulated Under the Clean Water Act? We suppose that you have knowledge of and access to the relevant analytical methods. These methods cover

what is the procedure for gsb proctor test for matrial sampling for lab density

Classification of lintels

1. All testing shall be done at room temperature. 2. No bearing shall be tested earlier than a week after vulcanization. 3. Bearing sections shall be cut from test bearings w

Q-  What are loads and forces taken into account for designing a pile and what is load carrying capacity of a pile. Ans. For designing a pile the following loads and force ar

Q. Preloading - Control of settlements? This method consists of loading the soil strata by a load intensity which will be equal to or higher than the expected load intensity. T

Explain the Equation for Length of Spiral Curve Length of Spiral Curve can be calculated using the following equation L s = 3.15V 3 /RC Where: V - Design Speed in MPH