engeenering drawing, Mechanical Engineering

how to fraw a parabolla in parallelogram
Posted Date: 9/2/2013 1:59:03 PM | Location : USA







Related Discussions:- engeenering drawing, Assignment Help, Ask Question on engeenering drawing, Get Answer, Expert's Help, engeenering drawing Discussions

Write discussion on engeenering drawing
Your posts are moderated
Related Questions
three vertical, parallel straight rods, each 2.6m in length have their upper ends firmly secured and their lower supporting a rigid horizontal bar with a weight of 8KN, which cause

How to design a flat form tool when the form of the workpiece is given.

Q. Storage and Handling of Epoxy Powder? Coating materials shall be stored, handled and applied in strict accordance with procedures as outlined by the coating manufacturer, ex

Q. Lap-Type Flange-To-Shell Clearance? Lap-Type Flange-To-Shell Clearance The difference between the flange ID and the shell OD shall not exceed: • 1/16 in (1.6 mm) for n

State the four classes of engineering materials 3 (b) Identify the class which each of the following materials belong to. Present your answer in table form Silicone, concrete, chro

proportional controller for lube oil temperature of engine working diagram

When and why the Multi-plate clutch is used ? Illustrate the working and constructional features of a multi-plates dry clutch. Describe clearly the necessity of a transmission s

Show schematic diagram showing the layout of transmission system of four-wheel driven car. Explain briefly the following types of frame: (a) Conventional frame (b) Integra

Explain desirable properties of modeling and differentiate between the process of casting and modeling. Also highlight the advantages and disadvantages of casting process and model

Consider a trapezoidal channel with a bottom width of 4 m, side slopes of 3:1 (H:V), and a bottom slope of 0.002 that carries 50 cms. The channel has a Manning's roughness of 0.034