Energy stored in the coil, Electrical Engineering

The term representing the energy stored in the coil may be written in terms of the inductance of the coil as...

840_Energy stored i coil.png

The energy stored in the coil increases with the square of the current flowing through it and in proportion to the value of the coil inductance 

2269_Energy stored i coil1.png

Posted Date: 8/27/2012 6:08:11 AM | Location : United States







Related Discussions:- Energy stored in the coil, Assignment Help, Ask Question on Energy stored in the coil, Get Answer, Expert's Help, Energy stored in the coil Discussions

Write discussion on Energy stored in the coil
Your posts are moderated
Related Questions
Static Rotor Resistance Control Methods This method is used only for slip  ring induction motor in SRIM  3- phase  variable  resistor can be inserted in the rotor  circuit and

A coil has an inductance of 1.2H and a resistance of 40? and is connected to a 200 V, d.c. supply. Verify the approximate value of the current flowing 60 ms after connecting the co

A three stage switching structure is to accommodate N = 128 input and 128 output terminals. For 16 first stage and 16 last stage, verify the number of cross points for nonblocking.

Define ruled surface and surface of revolution. Illustrate in detail B-spline and cubic Bezier surfaces with their important properties.

Consider and obtain the values for R S , R 2 , R 1 , and R D . Apply the rule-of-thumb dc design procedure outlined in this section for a JFET with V P = 3V, I DSS = 20 mA, and a

Design a low noise amplifier using an Infineon RF transistor BFP640. The amplifier is to be used to amplify the L2 GPS signal and so the centre frequency is 1227MHz and bandwidth 4

Logically AND the contents of memory Contents of memory  location,  whose address is specified by HL register pair are logically AND with the  contents  of the accumulator. The

Q. A 300-kVA transformer has a core loss of 1.5 kW and a full-load copper loss of 4.5 kW. (a) Calculate its efficiency corresponding to 25, 50, 75, 100, and 125% loads at unity

Explain SEGMENT assembler directive with example. SEGMENT: This directive described to the assembler the start of a segment along with name segment-name. The seg

By a simple time multiplexing of natural samples over a single line, a large radar site transmits 85 analog signals, each with 200-Hz bandwidth. If the sampling is done at twice th