Energy conservation building codes, Electrical Engineering

Energy Conservation Building Codes

It encompass the norms and standards of energy consumption expressed in terms of per square meter of the area wherein energy is used.

The main provisions of the Act on Energy Conservation Building Codes are as given below:

  1. The BEE would prepare guidelines for Energy Conservation Building Codes (ECBC);
  2. ECBC would be remembered to suit local climate conditions or other compelling factors through the respective states for commercial buildings constructed after the rules relating to energy conservation building codes have been notified. Additionally, these buildings should have a linked load of 500 kW or contract demand of 600 kVA and above.
  3. Energy audit of specific designated commercial building consumers would also be prescribed. Through energy audit, we mean verification, monitoring and analysis of energy use involving submission of technical report containing recommendations for improving energy efficiency with cost advantages analysis and an action plan to decrease energy consumption.
Posted Date: 2/1/2013 12:22:19 AM | Location : United States







Related Discussions:- Energy conservation building codes, Assignment Help, Ask Question on Energy conservation building codes, Get Answer, Expert's Help, Energy conservation building codes Discussions

Write discussion on Energy conservation building codes
Your posts are moderated
Related Questions
Regenerative Braking Control In this  methods  motor  behaves like a  generator  and the kinetic energy of the  motor  and connected load is  returned to the supply. If means

With a block diagram explain fiber optic communication system Ans: The block diagram of a fiber optic communication system is display below: The input signal is giv

Q. When the two-wattmeter method for measuring three-phase power is used on a certain balanced load, readings of 1200W and 400W are obtained (without any reversals). Determine the

list the key parameters to describe the ideal operational amplifier

Explain Node-voltage and mesh-current analyses? The node-voltage and mesh-current methods, which complement each other, are well-ordered systematic methods of analysis for solv

Three Logic Levels are used and they are High, Low, High impedance state. The high and low are normal logic levels & high impedance state is electrical open circuit conditions. Tri

Magnetic materials

Tardy Billing and Poor Revenue Collection Prolonged disputes, connivance, lack of consumer friendly policies, incorrect identification of category, fictitious billing (of non-

Transistor A transistor is a semiconductor device that is employed to amplify and switch electronic signals. It is made up of a solid piece of semiconductor material, with min

Q The electric ?eld intensity due to a point charge in free space is given to be (-¯ ax -¯ ay +¯ az)/√ 12V/mat (0,0,1) and 6 ¯ az at (2,2,0) Determine the location and the value