Embrittlement-metallurgical defects, Mechanical Engineering

Embrittlement

For use, at high strength, coupled with good notch toughness, all weld structure must  be Tempered low carbon martensite. Carbon and alloy steels having more than 0.18 % carbon tends to form brittle martensite structure in weld HAZ. This is avoided by controlled cooling rate.  The Embrittlement is measured by notch toughness values.

Posted Date: 9/18/2012 12:50:33 AM | Location : United States







Related Discussions:- Embrittlement-metallurgical defects, Assignment Help, Ask Question on Embrittlement-metallurgical defects, Get Answer, Expert's Help, Embrittlement-metallurgical defects Discussions

Write discussion on Embrittlement-metallurgical defects
Your posts are moderated
Related Questions
Slip of belt: Sol:   When the driver pulley rotates, it carries belt, because of a firm grip between its surface and belt. The firm between pulley and belt can be obtained by

Newton law of motion: Secon d Law The rate of change of momentum is proportional to external force applied on the body and take place, in the same direction in which the

Draw the bending moment and shear force diagram for the following cases : a) A cantilever beam of length (L) carrying a Point load (W)at its free end. b) A simply supported b

Characteristics of the secondary circuit The dimensions of the secondary circuit in secondary loop determine to a large extent, the performance of these machines. The secondary

hello,my name is mustapha from iran I want design piston engine (structure design cranckshaft ,rod,bearing,...)

Aeronautical engineering is a branch of aerospace engineering, thus some people use the 2 terms interchangeably. It is also sometimes considered that aeronautical engineering cover

A Torsion dynamometer is used in a propeller shaft of a marine Engine. It is found that the shaft twists 2 o in a length of 20 meters at 120 r.p.m. If the shaft is hollow with 300

A rectangular plate has two holes of dimensions shown and is released from the position shown. The plate is hinged about a horizontal axis and can rotate in the vertical plane. An

Lasers with Solid State Lasing Mediums For an active medium, the solid state laser uses lasing ions which are suspended in a rod shaped solid matrix. These "dopants" in the rod

which material is used in production of solid revits