Electronic Devices, Electrical Engineering

To demonstrate a practical method of testing semiconductor diodes.
Posted Date: 1/24/2015 3:58:12 AM | Location : Pakistan







Related Discussions:- Electronic Devices, Assignment Help, Ask Question on Electronic Devices, Get Answer, Expert's Help, Electronic Devices Discussions

Write discussion on Electronic Devices
Your posts are moderated
Related Questions
Modern complex systems are normally constructed by interconnecting sub-units. Therefore the systems engineer is often not too concerned about the details of what is inside these

The RAKE receiver exploits multipath channel characteristics and scrambling codes with good cross-correlation properties to realize a maximum ratio diversity combiner. Multipath pr

A 3 phase, 6 pole induction motor is rated at 400hz, 150v, 10h.p., 3% slip at rated power output. The windage and friction loss is 200w at rated speed. With the motor operating at

Next, let us consider the case of a balanced delta-connected load with impedance of 5 45° supplied by a three-phase, three-wire 100-V system, as shown in Figure (a). We shall dete

What do you understand by solid modeling and wireframe modeling in CAD systems? Explain and compare the both modellings. Describe the following 1. Boundary representation 2.

This problem concerns entropy There are hundred students in a midterm exam. There are 5 grades and the number of students having each grade is shown below. At a min

design using softwares (LEdit7, LTspice) the project has many aspects and I would like you to check them on the website with my personal password. in the project specifications (d

Checking at Site - Testing of Meter The routine testing of meters should be carried out once in 3 years. Further, surprise checks should be conducted at the consumer's install

commutator in d.c machine acts as... what????

A 4000-V, 5000-hp, 60-Hz, 12-pole synchronous motor, with a synchronous reactance of 4  per phase (based on cylindrical-rotor theory), is excited to produce unity power factor at