Electromagnetic torque, Electrical Engineering

The torque produced by each conductor in the field will be: 

1875_electromagnetic torque.png

where A is the area of the armature winding in the magnetic field, Ia is the current in armature winding, and B is the flux density which is proportional to the current of filed winding If 

891_electromagnetic torque1.png

1503_electromagnetic torque2.png

where km = the 'machine constant'. 

Posted Date: 8/27/2012 6:31:03 AM | Location : United States







Related Discussions:- Electromagnetic torque, Assignment Help, Ask Question on Electromagnetic torque, Get Answer, Expert's Help, Electromagnetic torque Discussions

Write discussion on Electromagnetic torque
Your posts are moderated
Related Questions
List the various addressing modes present in 8086? There are 12 addressing modes are present in 8086. They are, (a) Register and immediate addressing modes _  Register ad

Q. Show Maximum Differential Input Voltage of amplifier? This is the maximum value of differential input voltage v p - v n that can be applied without damaging the op amp.

Q. What do you mean by Feedback in amplification? Feedback :   Feedback in its broadest sense means that a certain amount of the output signal is "fed back" into the input. An

Explain Series capacitors These are connected in series with the line conductors and are used to reduce the inductive reactance of long transmission lines and hence the voltage

Explain the Procedure for design of Sequential Circuits? The design of the synchronous sequential circuit starts from a set of specifications and culminates in a logic diagram

When both  MT 2 and  Gate  are positive In this  junction  P 1 N 1   and P 2 N 2   are forward  biased whereas junction N 1 P 2 is reverse biased. The gate current flows  thr

Role of Consumers in Distribution Reform In the reforms procedure, mandatory metering for all consumers is being implemented.  Consumers should implement this measure. Public

Q. The K map of a logic function is shown in Figure, in which ds denote don't-care conditions. Obtain the SOP expressions.

Find the current flow through each resistor using mesh analysis for the circuit below. Step : Determine the number of common nodes and reference node within the network

It is uneconomic to provide adequate equipment to carry all the traffic which could possibly be offered to a telecommunication system. In a telephone exchange it's theoretically po