electric helicopter, Electrical Engineering

examples in building electric helicopter using cardboard, balsa wood, scotch tape, glue, binder clips, rubber bands, rubber stoppers, etc.
attached to a 12v power supply
Posted Date: 11/5/2012 1:28:51 AM | Location : United States







Related Discussions:- electric helicopter, Assignment Help, Ask Question on electric helicopter, Get Answer, Expert's Help, electric helicopter Discussions

Write discussion on electric helicopter
Your posts are moderated
Related Questions
A three-phase, wye-connected, 2300-V, four pole, 1000-kVA, 60-Hz synchronous machine has a synchronous reactanceXs = 5, a field resistance Rf = 10, and an approximately linear ma

explain measurement of frqueny and phase using cro

a shunt motor supplied at 230V rms runs at 900rev/min when the armature current is 30A.the resistance of the armature circuit is 0.4 ohms.find the armature input

Q. Consider the magnetic circuit shown in Figure. Assume the relative permeability of the magnetic material to be 1000 and the cross-sectional area to be the same throughout. Deter

Is there any electronics related papers like digital for free download


Linearize the swing equations around an equilibrium point. Compute the transfer function from the input U to the output !. For which equilibria is the linearizes system stabl

Q. Explain about Rotating Machines? Themost widely used electromechanical device is a rotatingmachine, which utilizes themagnetic field to store energy. The main purpose of mos

The  programming  Model of 8085 Microprocessor The programming  model  of 8085 microprocessor is  shown in figure  below in this  model  various 8 bit  and 16  bit registers a

i would like to construct a colpitts oscillator using a series lc tank circuit as a feedback. the circuit will have a frequency of 150 Khz and it will drop when varying the value o