Ei enable interrupts instruction , Electrical Engineering

EI Enable Interrupts  Instruction

The interrupt enable flip  flop  is set  and all the interrupts  of 8085  microprocessor are  enabled  which are  disabled  by DI  instruction or otherwise. The instruction format is

           EI

 

Posted Date: 4/5/2013 2:34:21 AM | Location : United States







Related Discussions:- Ei enable interrupts instruction , Assignment Help, Ask Question on Ei enable interrupts instruction , Get Answer, Expert's Help, Ei enable interrupts instruction Discussions

Write discussion on Ei enable interrupts instruction
Your posts are moderated
Related Questions
National Tariff Policy or NTP In the draft of NTP, it is suggested that although setting the tariff ERC should introduce performance-based cost of service regulations, a clear

INR (Increment )  Instruction This  instruction is used to  increment  the contents  of any  register or memory  location by one. There  are two  format.

Q. Explain the term total harmonic distortion. Describes the functionary of a total harmonic distortion analyzer. Total Harmonic Distortion: Nonlinear behaviors of circuit el

The superposition theorem states: 'In any network made up of linear resistances and having more than single source of e.m.f, the resultant current flowing in any branch is the

Properties of Conductors and Insulators: This unit provides the basic characteristics or properties of the most common materials which are classified as semiconductor, conduct

Q . Differentiate between an integrator and differentiator? Integrators 1 Integrators are circuits in which output voltage is proportional to the integral of the input.

Question: (a) Consider the subsequent LC impedance function: (i) If the function is to be realised using the Foster I Form, evaluate the values of the different compon

Q. Explain Common emitter configuration? Common emitter configuration: In this circuit the emitter is common to both input and the output.Such a configuration is also known as

Q. The magnetization curve taken at 1000 r/min on a 200-V dc series motor has the following data: Field current, A: 5 10 15 20 25 30 Voltage, A: 80 160 202 222 236 244 Th

A single phase line has an impedance of 8.4 + j11.2 ?. The line feeds a load consisting of a resistor and an inductor connected in parallel as shown in Figure 1. The load is absorb