Draw a circuit using the cascade system, Electrical Engineering

Design and draw a circuit using the cascade system to operate two cylinders (A and B) which, on the operation of a start valve, produces the sequence A - B + B - A+. The cylinders should park in the positions B - A + when the start switch is in the ‘off' position.

Posted Date: 3/30/2013 5:41:50 AM | Location : United States







Related Discussions:- Draw a circuit using the cascade system, Assignment Help, Ask Question on Draw a circuit using the cascade system, Get Answer, Expert's Help, Draw a circuit using the cascade system Discussions

Write discussion on Draw a circuit using the cascade system
Your posts are moderated
Related Questions
explane the special features of dual beam?


Fast  Recovery diodes The fast  recovery  diodes low recovery times. These diodes  are manufactured by diffusion. They are used in converter circuits where  the speed  of reco

(a) Find the Thevenin equivalent of the circuit shown in Figure (a) at the terminals A-B. (b) Determine the impedance that must be connected to the terminals A-B so that it is m

Q. Binary Coded Decimal Addition Now as in conventional decimal addition, Binary Coded Decimal addition is performed one decimal digit at a time. What happens when the sum g

Q. Open-circuit and load characteristics of generator? The open-circuit and load characteristics of a separately excited dc generator, along with its schematic diagram of conne

Explain the Bidirectional Shift Registers? A Reversible or A Bidirectional shift register is one in which the data can be shift either left or right. D flip-flops are used by

Speed  Control of Three  Phase Induction Motors Three  phase  induction motors are invariably used in the application where in speed in  required to be  constant  or adjustabl

Voltage Doubler: The network of Fig. is a half wave voltage doublers. During the positive voltage half cycle across the transformer, secondary diode D 1 conducts, charging ca

Q. Find load resistance and voltage? Let the amplifier block be connected to a current source at the input terminals, as shown in Figure(a), and to a load resistance R L at it