die design, Mechanical Engineering

#question calculate bending force
Posted Date: 2/21/2013 4:58:25 AM | Location : Indonesia







Related Discussions:- die design, Assignment Help, Ask Question on die design, Get Answer, Expert's Help, die design Discussions

Write discussion on die design
Your posts are moderated
Related Questions
a concrete column of 350mm diameter is reinforced with 4 bars of 25mm diameter . find the stress when the concrete is subjected to a stress of 4.5 MPa . also find the safe load in

Mechanical failure is one of the most important factors causing component/structure/product no longer fit for its intended purpose. Use examples to explain at least three modes o

Tachometer: This is used to measure the speed (revolutions) of an engine in revolutions per minute (RPM). This is shown in Figure. Figure : Tachometer

Vernier Calipers: It is used to measure internal as well as outer diameters of an object. There are separate jaws available for inside and outside diameter measurements. It can al


Use of trusses: Where do you find trusses in use? The main uses of truss are as follows: 1. The trusses are used to support slopping roofs. 2. Brick trusses are

Draw and Illustrate all the inversions of a double slider crank chain. Get an expression for the length of a belt in 1. an Open belt drive ;  And 2. a Cross belt drive.

Determine reactions of the overhanging beam: Determine r eactions at points A and B of the overhanging beam as shown in the figure given below.

A converging elbow (see Figure 4) turns water through an angle of 135 o in a vertical plane. The flow cross-section diameter is 400 mm at the elbow inlet, section (1), and 200 mm

Q. Show the tensile properties of material? Tensile properties indicate how the material will react to forces being applied in tension. A tensile test is a fundamental mechanic