Di disable interrupts instruction, Electrical Engineering

DI Disable  Interrupts Instruction

The interrupt enable  flip flop is reset and all the  interrupts of 8085 microprocessors  except  TRAP  are disabled . the  instruction  format is

DI

 

Posted Date: 4/5/2013 2:35:12 AM | Location : United States







Related Discussions:- Di disable interrupts instruction, Assignment Help, Ask Question on Di disable interrupts instruction, Get Answer, Expert's Help, Di disable interrupts instruction Discussions

Write discussion on Di disable interrupts instruction
Your posts are moderated
Related Questions
Q. A 10-hp, 230-V dc shunt motor takes a full- load line current of 40 A. The armature and field resistances are 0.25 and 230 , respectively. The total brush-contact drop is 2 V,

Q. Explain Charge-to-Charge Amplifier A circuit is shown in Figure in which there is a capacitor C1 in the - input line and a capacitor Cf in the feedback loop. KCL at node X g

Give the properties and application of bronze. Bronze : It is alloy of copper and tin. This alloy is very brittle and hard. Its corrosion resistance is better than brass. Bron

In a CDMA system, the signal is spread over a large bandwidth by multiplying the transmitted symbol by a sequence of short pulses, also called chips. The

Q. A two-pole, three-phase synchronous generator has a balanced three-phase winding with 15 turns per phase. If the three-phase currents are given by i a = 100 cos 377t, i b =

outline what three features you would add (choose the three that you feel would be most advantageous) to the 16 bit version of the processor in order to enhance its power.

Power in Balanced Three-Phase Circuits The total power delivered by a three-phase source, or consumed by a three-phase load, is found simply by adding the power in each of the

1. The voltage across a 1 - μF capacitor is given. Which is the sinusoidal expression for the current? a) 30 sin200t b) 70cos (800t - 20°) 2. At what frequency will the re

Q. A semiconductor diode with IS = 10µA and a 1-k resistor in series is forward-biased with a voltage source to yield a current of 30mA. Find the source voltage if the diode I-V e

Q. Explain working of TTL NAND gate? The TTL logic family uses only transistors instead of a combination of transistors and diodes. TTL has the same high and low ranges as DTL.