Determine the volumetric flow rate of the original feed, Chemical Engineering

Methane containing 4 mol% N2 is flowing through a pipleline at 105.1 kpa and 22 °C. To check this flow rate, N2 at the same temperature and pressure are introduced to the pipleline at the rate of 2.83 m3/min. At the end of the pipe (where the mixing has completed), N2 concentration is found to be 4.82 mol%. What is the volumetric flow rate of the original feed (before the addition of N2) in m3/min?

Posted Date: 3/9/2013 2:18:24 AM | Location : United States







Related Discussions:- Determine the volumetric flow rate of the original feed, Assignment Help, Ask Question on Determine the volumetric flow rate of the original feed, Get Answer, Expert's Help, Determine the volumetric flow rate of the original feed Discussions

Write discussion on Determine the volumetric flow rate of the original feed
Your posts are moderated
Related Questions
how to solve partial differential equation using matlab and also discreteing the pdf in matlab

1. What are chemical fuels? How they are classified?  List the characteristics of a good fuel. 2. Define cracking. Explain the fluidized catalytic cracking method with neat diag

Formulas for determining temporary and permanent hardness

Give the properties and applications of Teflon. Teflon: This is acquired by the polymerisation of tetrafloourethylene. Properties: 1. This has good electrical, therma

The similar system is now heated in two stages, by rst contacting with a reservoir at T2 halfway among T1 and Tf , then by contacting with the reservoir at Tf . Again and the ent

what is the heat capacity of Sodium lauryl sulfate

FIND THE REAL ROOT OF xexp^x=3 regula falsemethod correct the three decimal placess

Question:1 (a) A flowchart of a continuous steady state two-unit separation process is shown below (Figure 1.1). Each stream contains two components, x and y, in different prop

define emf and its application

Point defects: Point defects are defects which are not extended in space in any dimension. There is no strict limit for how small a "point" defect should be, but typically the ter