Determine the system active power, Electrical Engineering

A three-phase, 4160 V, 60 Hz, 3000 kVA generator supplies the following three phase loads:  A00 kVA at .7 pf lagging, D00 kVA at .9 pf lagging, and C50 kVA at unity pf.  Determine the system active power,  system reactive power; system apparent power, and system power factor. 

Posted Date: 2/28/2013 4:46:57 AM | Location : United States







Related Discussions:- Determine the system active power, Assignment Help, Ask Question on Determine the system active power, Get Answer, Expert's Help, Determine the system active power Discussions

Write discussion on Determine the system active power
Your posts are moderated
Related Questions
Q. Working of Equalizer circuit? Equalizer circuit: Equalizers are combination of passive components (capacitors, resistors and so on) that are used to regulate the amplitude a

Fundamental of Metal Casting: Fundamental of Metal Casting : Casting process is based on the property of a liquid to take up the shape of vessel containing it. Molten metal

Clipper Circuits: Clipper circuit have ability to Clipper of portions of the input signals without distorting the remaining part of the alternating wave form. Clamper net

Buck Converter In buck  converters the output  voltage is  always  less than the  input  voltage. The basic  circuit  of buck converter is shown  in figure. The operation of th

Q. Input offset current of operational amplifier? The adverse effect of the input bias current mentioned would be nulli?ed if both inputs were connected to equal resistances (o

can you please briefly explain about significance of the word direction in vectors with some valid points

What is the difference among 8085 and 8086 in microprocessor? Ans) 8086 has a special concept known as memory segmentation. It permits parallel processing, whereas 8085 does no

12. A capacitor is to be constructed so that its capacitance is 0.2µF and to take a p.d. of 1.25kV across its terminals. The dielectric is to be mica which, after allowing a safety

A TDM signal of the type is formed by samplingM voice signals at fs = 8 kHz. If the TDM signal then modulates the amplitude of a 4-MHz carrier for radio transmission, determine the

Objective of Long-Term Plans for Technical Loss Reduction The primary objectives of strengthening and improvement of sub-transmission and distribution system in the long-term