Determine the load and throughput in slotted aloha system, Computer Networking

In slotted Aloha system, it has been measured that 70% of slots are occupied by frames (i.e. the remaining slots are empty). 

a)  How many frames need to be transmitted, on average, to successfully send a frame to the destination?

b)  What are the load G and throughput S in this system?

Posted Date: 3/25/2013 6:27:33 AM | Location : United States







Related Discussions:- Determine the load and throughput in slotted aloha system, Assignment Help, Ask Question on Determine the load and throughput in slotted aloha system, Get Answer, Expert's Help, Determine the load and throughput in slotted aloha system Discussions

Write discussion on Determine the load and throughput in slotted aloha system
Your posts are moderated
Related Questions
What is a private IP address? Private IP addresses are allocated for use on intranets. These addresses are used for internal networks and are not routable on external public ne

Discuss an example of threats in computer software Assume only one attack out of the above list i.e., the virus attack. Though the present anti-virus software solutions can det

PROBLEM WITH BROADCASTING: There are some issues with the broadcast. For each broadcast frame on the network every computer uses computational sources and places the data into

Determine the functioning of Service Support Service Support must be considered a strong point for hardware, especially for servers and should be available readily. Many brande

OBJECTIVES After reading this unit, you should be able to: Describe the basics of parallel programming; Explain the parallel programming based on message passing;


a. If a password to a cipher is exactly 8 characters long, and each character can be selected from [0-9], [a-z], and [A-Z], how many different passwords are possible? b. Suppose

What is Forward Error Correction and data words Forward error correction It is the process in which the receiver tries to guess the message by using redundant bits. Da

Q. Advantages of Fiber Optics? - Higher bandwidth in comparison to twisted-pair and coaxial cable is not limited by medium but by equipment used to generate and receive signals

1. A low voltage digital device has a low state of 0 V and a high state of 1.8 V. It generates a signal train of high pulses at a rate of 1 MHz, these pulses having a 10 ns width a