Determine the apparent range of the target - radar system, Mechanical Engineering

Consider radar with a PRF of 5 kHz. What is the maximum unambiguous range Rua of this radar, in km?  If a target is located at a range of 50 miles, how many pulses will the radar have transmitted before the first echo from the target arrives?  What will be the apparent range of the target, in kilometers?

Posted Date: 3/7/2013 12:44:07 AM | Location : United States







Related Discussions:- Determine the apparent range of the target - radar system, Assignment Help, Ask Question on Determine the apparent range of the target - radar system, Get Answer, Expert's Help, Determine the apparent range of the target - radar system Discussions

Write discussion on Determine the apparent range of the target - radar system
Your posts are moderated
Related Questions
A Common Cell Control Software  In this section, fine and common implemented cell control software are developed, that is based upon a transition table, to show the restriction

(a) Draw P-H and T-S diagrams for following cases : (3) (i) Cycle with superheated vapour before compression. (ii) Cycle with sub-cooling or under-cooling of refrigerant.

Q. Flue Gas Excess Oxygen Control for steam generator? Air-gas ratio control provides approximate excess oxygen control. However, an in-situ oxygen probe measures the actual o

If Engine Does Not Start at Cranking Speed Causes of Problem Remedy Incorrect electrode gap of spark plug Fouled spar

Find out bulk modulus: A steel bar of 25 mm diameter was tested on a gauge length of 250 cm in tension and in torsion. A tensile load of 50 kN generated an extension of 0.13 m

The Linear Dimension Command                                    You can use this command to generate horizontal and vertical dimensions.Creating a linear dimension is eas

(a ) What are the demerits and merits of sliding mesh gear box? (b) Show a four speed gear box, including reverse speed for a passenger car and illustrate how the speed ratio is

Derive the relation for a fin insulated at the tip and the heat dissipation?

• IGF Vessel SH: CS + 1.6 mm CA + Internal Coating Eductor: 304L SS or alternatively, 12Cr • ORF Vessel SH: CS + 1.6mm CA + Internal Coating Mixer: 316L SS • Skim Oil T

Edge joints: The flanged edge joint is suit- able for plate 1/4 inch or less in thickness and can only sustain light loads. Edge preparation for this joint may be done.