Determine excitation voltage and power angle, Electrical Engineering

A 500KVA, 6 pole, 500v, 3 phase, wye-connected synchronous generator has a synchronous impedance of 0.1 + j1.5 ohms per phase. If the generator is driven at 1000 r.p.m., what is the frequency of the generated voltage? Determine the excitation voltage and the power angle on full load and 0.8 lagging power factor.

Posted Date: 3/5/2013 7:24:28 AM | Location : United States







Related Discussions:- Determine excitation voltage and power angle, Assignment Help, Ask Question on Determine excitation voltage and power angle, Get Answer, Expert's Help, Determine excitation voltage and power angle Discussions

Write discussion on Determine excitation voltage and power angle
Your posts are moderated
Related Questions
General Purpose Diodes The  general purpose  diodes  have relatively high reverse recovery time. The  diodes are general  made  by diffusion. They  are used  in low  speed  app

Port Address The port  address  is of 8 bit  it is range from 00H  to FFH. It means  there may be total  i 256 input  ports and 256  output  port which can be accessed by 8085

Enhancement type MOSFET In these types of devices operate by comprising a channel enhanced in the semiconductor material in which no channel was constructed, they are termed

What are the modes used in display modes? 1. Left Entry mode In the left entry mode, the data is going into from the left side of the display unit. 2. Right Entry Mode

The one line diagram of a simple power system is shown below.  The data of the system are given in the table below.  (a) Draw the impedance diagram of the system and mark all im

Fleming's Right-hand rule states: Let the thumb, first finger and second finger of the right hand be extended such that they are all at right angles to every other. If the first

Illustration of embedded web technology An oven comprise an embedded processor. Owner can use a web ready mobile phone anywhere to control the oven remotely. By accessing a

At what velocity must a conductor 75 mm long cut a magnetic field of flux density 0.6 T if an e.m.f. of 9 V is to be induced in it? Suppose the conductor, the field and the directi

\ Transistor voltmeter (TVM) : a simple diagram of TVM using two transistors in the bridge configuration is as shown. TVM is provided by using transistor bridge circuits. In b

what is working of dc machines?