Designated consumers - features of energy conservation, Electrical Engineering

Designated Consumers - Features of Energy Conservation

The Act gives the list of designated consumers, which involves the energy intensive industries, Railways, Port Trust, Transport Sector, Power Stations, Transmission & Distribution Companies and Commercial buildings or establishments. The government notifies the designated consumers.

The main provisions of the Act on designated consumers are as follows:

  1. The designated consumer should get an energy audit conducted by an accredited energy auditor.
  2. Energy managers are required to be appointed or designated by the designated consumers. They should have passed the Certification examination arranged through the Bureau.
  3. Designated consumers would comply along with norms and standards of energy consumption as prescribed through the GOI.
Posted Date: 2/1/2013 12:20:24 AM | Location : United States

Related Discussions:- Designated consumers - features of energy conservation, Assignment Help, Ask Question on Designated consumers - features of energy conservation, Get Answer, Expert's Help, Designated consumers - features of energy conservation Discussions

Write discussion on Designated consumers - features of energy conservation
Your posts are moderated
Related Questions
Connect the TTL output (square wave) of the "Audio Oscillator" to the "Scope Selector". Adjust the frequency of the square wave to 2 kHz. Observe and record the time domain pict

What is TSR? TSR: The TPA also as TSR stand for terminate and stay resident programs which remain in memory in an active state till activated by a hot-key sequence or other eve

Q. (a) Obtain a Thevenin equivalent circuit at terminals A-B in the circuit. (b) What impedance ¯ZL, when connected to A-B, produces maximum power in ¯ZL? (c) Find the val

a) What is meant by frequency response and how would you check the performance of your amplifier? b) Calculate the Voltage Gain of your amplifier at a range of frequencies suffic

Q. Find idealized expressions for the active and ohmic states and sketch the universal characteristics of an n-channel enhancement MOSFET operated below breakdown.

Bureau of Energy Efficiency Setting up of the Bureau of Energy Efficiency The Bureau of Energy Efficiency has been established with effect from 1st March, 2002 under the

If the stator windings of an alternator were to be supplied by an AC of frequency f (as opposed to drawing an AC current from them as would be the case for an alternator) then

Zener breakdown: Zener Breakdown takes place in very thin junction i.e. when both sides of junction layer is narrow. When a small reverse bias voltage is applied a Very strong

Q. Frequency stability of quartz crystals ? The amount of frequency deviation from the ambient temperature frequency over the operating temperature range. This deviation is ass

Discuss about signal distortion in optical waveguides Ans: The major reason for signal distortion within optical waveguide is dispersion. Dispersion of the transmitted