design project , Chemical Engineering

design a falling film evaporator in detail
Posted Date: 1/24/2013 6:09:27 AM | Location :







Related Discussions:- design project , Assignment Help, Ask Question on design project , Get Answer, Expert's Help, design project Discussions

Write discussion on design project
Your posts are moderated
Related Questions
Explain the problems of flooding and channeling in packed tower

What is the aim of shear stress distribution?


the inlet diameter of venturimeter 25mm and diameter of throat is 15mm.The coefficient of discharge for venturimeter is Cv=0.98.The height is found to be 5ml density of water is 10

PROCEDURE : Visit any lab (physics, chemistry or biology) of your study centre or any other you can get access to and note its features. To guide you through we have listed below

A large tower is to be supported by a series of steel wires; it is estimated that the load on every wire will be 13,300 N (3000 lbf). Verify the minimum needed wire diameter, assum

Water from a supply having a total head of 100 ft is used in the jet of an ejector in order to lift 10 ft3/s of water from another source (at a lower level) that has a total head o

Hardness is 160 ppm and flow rate is 40 m3/hr ,I want to know the amount resin quantity required.Please give me a solution with details.

Your first assessment will cover the design of a monolith reactor for the VOCs removal. Therefore, you are asked to do the following: 1. Choose a specific VOC; 2. Search for the

Polarization of Dielectric If a material having polar molecules, they will usually be in random orientations when no electric field is applied. An applied electric field will p