Describing the steady state effect , Electrical Engineering

Select the response describing the steady state effect of increasing the air gap for otherwise identical devices, one operating with constant DC voltage excitation and one with constant AC voltage excitation.

2002_DC and AC.png

Comments (if you wish to show your work, explain your answer or defend your assumptions:

Posted Date: 2/15/2013 6:29:43 AM | Location : United States







Related Discussions:- Describing the steady state effect , Assignment Help, Ask Question on Describing the steady state effect , Get Answer, Expert's Help, Describing the steady state effect Discussions

Write discussion on Describing the steady state effect
Your posts are moderated
Related Questions
Q. What are the uses of MOSFET? The most common use of MOSFET transistors today is the CMOS (complementary metallic oxide semiconductor) integrated circuit which is the basis f

Determine the total energy loss: Two capacitors C 1 = 50 μF and C 2 = 100 μF are connected in parallel across 250 V supply. Determine the total energy loss. Figure

Determine the Type of the Semiconductor An unknown semiconductor has E g =1.1 eV and N t =N v . lt is doped with 10 16 /cm 3 donor atoms. - (a) Determine the type of the s

Discuss the need of PCI bus. Peripheral Component Interconnect (PCI): It was developed by Intel and introduced in 1993 year. This is geared particularly to fifth- and sixth-

In my designed analog circuit,efficiency is measured at steady state or transient state of my output node? Efficiency of MOSFET circuit given in datasheets of any product is measur

Future scope on MATLAB in India

Explain protected mode interrupt. In this mode, interrupts have exactly similar assignments as in real mode, but the interrupt vector table is not same. In place of interrupt

design 4 bit binary coded decimal to excess 3

Write explanatory notes on Hard disk drive controller. Hard disk drive controller: It converts instructions from software running upon the computer to the electrical signals

Digital Transmission on Fading Multipath Channels We have discussed thus far digital modulation and demodulation methods for the transmission of information over two types of c