Describe the features of physical survey phase, Civil Engineering

Describe the features of physical survey phase

The Physical Survey (field and laboratory test) for the purpose of determination of physical and engineering properties of the materials to the extent required to evaluate the material behaviour. This phase does not limit to the determination of properties based on a few samples, but also necessitates a reliable estimate of the average values for the entire strata under consideration

 

Posted Date: 9/3/2013 5:26:11 AM | Location : United States







Related Discussions:- Describe the features of physical survey phase, Assignment Help, Ask Question on Describe the features of physical survey phase, Get Answer, Expert's Help, Describe the features of physical survey phase Discussions

Write discussion on Describe the features of physical survey phase
Your posts are moderated
Related Questions
Question Under which situation ought to engineers use pot bearings instead of elastomeric bearings ? Answer In an event of high vertical loads shared with large angl

Ask question #WHAT is presentation skill #

is it necessary for to put plinth wall in buildings

Classification of the damage according to the type of structures   The level of damage in spatial trusses has also been classified into three different levels based on the t

A saturated clay layer 4 m thick is located 6 m below GL. The void ratio of the clay is 1.0. When a raft foundation is located at 2 m below GL, the stresses at the top and bottom o

What are the long spam bridge girders The pre-tensioned construction finds more use and application in the construction of those structural concrete members which are of small

With a clear sketch indicate the system of protection of line for works of short duration where ‘ Stop dead restriction' need to be observed on a single line section on a BG track.

Minimum volume of sump volume for pumps Maximum pumping rate = Q P Volume of sump = V Inflow Rate = Q i Cycle Time T c = t 1 + t 2 t 1 = V / Q P - Q i t 2

fabrication methods of ironmongery

difference between flat slab and normal slab