Derive the equation for the pressure difference, Mechanical Engineering

The differential manometer (shown below) is used to measure the pressure difference between two vessels. Derive the equation for the pressure difference (pA - pB) in terms of the liquid heights and densities.

1695_density.png

Posted Date: 3/19/2013 1:14:03 AM | Location : United States







Related Discussions:- Derive the equation for the pressure difference, Assignment Help, Ask Question on Derive the equation for the pressure difference, Get Answer, Expert's Help, Derive the equation for the pressure difference Discussions

Write discussion on Derive the equation for the pressure difference
Your posts are moderated
Related Questions
BASIC DEFINITIONS - Air transportation: A civil engineer dealing with airport engineering shall have to know the precise meaning of some terms. These are defined below :

If Engine Does Not Start in Wet or Damp Weather Causes of Problem Remedy   Insulators are not clean and dry Fuel t

In most hardware stores, you can find what has known as a Heat Gun. Hold the heat gun about 6 inches away from the acrylic you intend on bending say the bumper on a car. They are p

Four Stroke Engine - thermodynamics: Figure given below shows the working of a four stroke engine. During suction stroke only air (in case of diesel engine) or air with petrol

Using Mohr's Circle Method determine the stresses acting on the plan as shown in figure. Also write the procedure.

(Rigid body acceleration) A tank of water accelerates down an icy frictionless ramp of angle . What angle ( ) does the water make with the horizontal at equilibrium?

Air Filter Cleaning :  Air filter filters the air, which enters into the carburetor. Then, this air mixes with fuel and this mixture enters into engine. If air is not clean, it wi

You are required, as part of a small team, to design a remote controlled buggy that can be made to move forwards, backwards and from side to side. The basic buggy and motors are pr


A solid shaft of diameter d is taken in power transmission. Because of modification of existing transmission system, it is needed to replace the solid shaft by a hollow shaft of th