Degree of super heat - thermodynamics, Mechanical Engineering

Degree of Super Heat:

It is difference between the temperature of superheated steam and saturation temperature resultant to the given pressure.

So, the degree of superheated = tsup - ts

Where;

tsup  = Temperature of superheated steam

ts  =  Saturation temperature corresponding to given pressure of steam generation.

Super Heat

It is quantity of heat needed to transform unit mass of dry saturated steam to unit mass of superheated steam at constant pressure so that,

Super heat = 1 × Cp  × (tsup  - ts) KJ/Kg

Saturated Water

It is that water the temperature of which is equal to the saturation temperature corresponding to given pressure.

 

Posted Date: 10/15/2012 6:10:15 AM | Location : United States







Related Discussions:- Degree of super heat - thermodynamics, Assignment Help, Ask Question on Degree of super heat - thermodynamics, Get Answer, Expert's Help, Degree of super heat - thermodynamics Discussions

Write discussion on Degree of super heat - thermodynamics
Your posts are moderated
Related Questions
Determine the percentage savings in the material: A hollow shaft containing an inside diameter 0.5 times the outer diameter is to replace the solid shaft of the similar materi

Thermodynamic process - Thermodynamics: Thermodynamic system undergoes changes because of the energy and mass interactions. Thermodynamic state of system changes because of th

A hollow circular shaft has an internal diameter of 48 mm and an external diameter of 54 mm. Calculate the shear stress produced at the outer and inner surfaces of the shaft when t

The different advantages of alloy steel are as: (a) Higher strength, toughness and hardness upon surface and over bigger cross-section. (b) Better harden-ability and retentio

Objectives of the Registration Scheme They are summarized as follows: To enumerate and maintain a roll of small industries to which the package of incentives and suppor

Q. Inlet channel of the exchanger? The inlet channel of the exchanger shall be designed to minimize flow turbulence and erosion of the refractory liner and the tube inlet area.

Calculate the force - pulley: A string is passing over a smooth pulley. The string supports the mass m on one side which is to be pulled up with acceleration a. calculate the

The extent of a hazardous area depends on the rate of release, ventilation conditions, and fluid properties and is defined by the relevant regional or country standards. The pot

Resulting structure of steel: Heat treatments as mentioned below are given to thin steel strips for which TTT diagram is as shown in Figure 19. What will be the resulting stru

Step s Involved for Method of Section: The different steps involved are stated below: (1) First find out support reaction by using equilibrium conditions. (2) The truss