Define role of diver in underwater inspection of bridge, Civil Engineering

Define Role of Diver in Underwater Inspection of Bridge?

Diver's role is primarily to point out a potential scour problem. The diver can use one of the following equipment to measure the scour. - Sounding /sensing devices* - Diver investigations.

Posted Date: 6/13/2013 1:49:49 AM | Location : United States







Related Discussions:- Define role of diver in underwater inspection of bridge, Assignment Help, Ask Question on Define role of diver in underwater inspection of bridge, Get Answer, Expert's Help, Define role of diver in underwater inspection of bridge Discussions

Write discussion on Define role of diver in underwater inspection of bridge
Your posts are moderated
Related Questions
A retaining wall 9 m high retains granular fill weighing 18 kN/m 3 with level surface. The active thrust on the wall is 180 kN per metre length of the wall. The height of the wall

Q. Purpose of setting minimum amount of longitudinal steel areas for columns? In some design codes it specifies that area of longitudinal steel reinforcement must be not less

Define Superposition Method  1. Remove enough redundant supports to reduce the structure to a statically determinate condition 2. Calculate the deflections at the previous l

Determine the condition of each activity in the network flow diagram shown below   Ans: a. Activity C can be started only after the completion of activities A and


A square pile group of 16 piles passes by a filled up soil of 3 m depth. The pile diameter is 25 cm and pile spacing is 75 cm. If the unit cohesion of the material is 18 kN/m 2 an

The Figure 1 below shows a section through a stairway for a garage in a new proposed dwelling. The stairway is 3 meters wide with 300 mm wide treads(7 treads) and 170 mm high riser

In i ncremental launching mode of bridge construction, what are ways adopted to increase sufficient resistance of superstructure during launching practice?

slope deflection with settlement

Q. Define Well Steoning? It is the side wall of well foundation. It is built of masonry or cement concrete not less than M 10 grade, sufficient bond rods should be provided to