Define abcd propagation , Electrical Engineering

ABCD propagation of an optical ray through a system can be described by a straightforward two by two  matrix. In ray optics, the feature of a system is known by the corresponding ray matrix associated the ray's position from the slope and axis at the input to those at the output.

 

Posted Date: 7/26/2012 12:43:16 AM | Location : United States







Related Discussions:- Define abcd propagation , Assignment Help, Ask Question on Define abcd propagation , Get Answer, Expert's Help, Define abcd propagation Discussions

Write discussion on Define abcd propagation
Your posts are moderated
Related Questions
Q. Explain about Differentiator? Shown in Figure is a differentiator which is obtained by replacing R1 in the inverting amplifier of Figure by a capacitor C. Assuming ideal op-

A 3 phase, 6 pole induction motor is rated at 400hz, 150v, 10h.p., 3% slip at rated power output. The windage and friction loss is 200w at rated speed. With the motor operating at

block diagram of eigen face,Viola & Jones Method,Bio-ID,RWTH-i6 Groups of People Database

Hysteresis results in a dissipation of energy Hysteresis results in a dissipation of energy which appears as a heating of the magnetic material. The energy loss associated wit

Q.   Draw the various characterstics of a DC shunt generator and explain critical resistance.   Sol.  Following are three most important characterstics or curves of a d.

Q. A depletion MOSFET is given to have large V A , V P = 2.8V, I DSS = 4.3 mA, v DS = 4.5V,and v GS = 1.2V. (a) Is theMOSFEToperating in the active region? (b) Find iD.

Using the audiorecorder() function in MATLAB, make a recording of your voice. Use a sample rate of 8kHz, 16 bits per sample, and aim to record around 2 seconds worth. Quantize the

The magnetic field can be supplied by coils supplied from the output of the generator itself. This is known as self-excitation.There are three ways that the field coils can be conn

Next, let us consider the case of a balanced delta-connected load with impedance of 5 45° supplied by a three-phase, three-wire 100-V system, as shown in Figure (a). We shall dete

There is a force on the plunger required to do to move it into or out of the gap and work must be done by or against this force. The conservation of energy dictates that the change