Decision making, Electrical Engineering

Decision  Making

The rhombus diamond symbol  is used to represent  the decision making  process  as shown  below.

2381_Decision  Making.PNG

                                         Figure  Decision Making symbol

Posted Date: 4/5/2013 3:20:53 AM | Location : United States







Related Discussions:- Decision making, Assignment Help, Ask Question on Decision making, Get Answer, Expert's Help, Decision making Discussions

Write discussion on Decision making
Your posts are moderated
Related Questions
Q. Explain the working of LEDs OPTOELECTRONIC devices either produce light or use light in their operation. The first of these, the light-emitting diode (LED), was developed to

in 8085 name the 16 bit registers

Q. Explain working of Presentation Layer? This is concerned with format of the data represented, in order to overcome difference in representation of information as supplied to

Q. A gyrator is sometimes used in integrated circuits to simulate inductances. Consider the circuit of Figure consisting of a gyrator. (a) Show that the impedance as seen to the

What is mgnomotive force

how can we increase insulation resistance of sheet

Flicker noise: I’d like to plot the graph of the flicker noise found in the data sheet for the amplifier (will be provided later) and also generate the equation for that graph sho

Reproducibility and repeatability are measures of closeness with which a given input may be measured over again. The two terms cause confusion. Therefore, a distinction is made bet

Q. Common-Drain JFET Amplifier? Figure (a) shows a CD JFET amplifier in which resistors R 1 , R 2 , and R SS are selected by the bias design, and capacitors CG and CS are chos

Mixed Mode Simulator: The circuit is preprocessed. The test points and waveform markers are located in input and output of the circuit. GND net is set like reference net.