Control bus -bus organisation, Electrical Engineering

Control  Bus

The control  bus comprises of various  single  lines that carry  various  control  signals for synchronizing  various devices  and performing different task. The microprocessor general specific  control  signals  for different  operations.

Posted Date: 4/4/2013 3:10:17 AM | Location : United States







Related Discussions:- Control bus -bus organisation, Assignment Help, Ask Question on Control bus -bus organisation, Get Answer, Expert's Help, Control bus -bus organisation Discussions

Write discussion on Control bus -bus organisation
Your posts are moderated
Related Questions
a. Describe the meaning of standing wave ratio. What is the formula for it, if the load is purely resistive? Why is a high value of SWR often undesirable? b. Determine how the c

Q. What do you mean by Transconductance? The  control that the gate voltage has over the drain current is measured by transconductance and is similar to the transconductance of


Design a combinational logic circuit to convert XS3BCD code in to the  standard 8421 BCD code.

Q. Design the high-pass filter shown in Figure (by determining C) to have a half-power frequency of 1 MHz.

if the prime mover input of an alternater connected directly to an infinite bus in increased,then its?

(a) Design a 6-bit R-2 R ladder D/A converter. (b) For V ref = 10 V, find the maximum output voltage. (c) Determine the output voltage increment. (d) If the output voltag

Metering Standards Relevant standards on metering are given in Table. Table: Relevant Metering Standards  Standards Description

Question: An evaporator is a device in which a feed stream is concentrated by boiling a solution. A combination of heating and reduced pressure are used to induce the boiling.

Binary  Number Systems As mentioned  earlier this  number is used by  digital  systems like  microprocessor  and other  digital  circuits. This  number  systems  use only two