Construction of steam turbine , Mechanical Engineering

Construction of steam turbine :

CONSTRUCTION DETAILS:

1. Casing: It is made out of cast steel. The casing has rotor inside it.

2.  Rotor: It carries blades or buckets.

3.  Nozzle : It provides flow passage for steam where expansion of steam takes place.

4.  Frame: It provides support to the rotors, stator and all other mountings. It can be integral part of stator in case of small tubines.

 

Posted Date: 10/20/2012 3:49:58 AM | Location : United States







Related Discussions:- Construction of steam turbine , Assignment Help, Ask Question on Construction of steam turbine , Get Answer, Expert's Help, Construction of steam turbine Discussions

Write discussion on Construction of steam turbine
Your posts are moderated
Related Questions
The Shaft is made of a material with an allowable shear strength of 80 Mpa. a.       Develop the torque diagram b.      Determine the minimum acceptable diameter of the shaft

Q. What is Transfer molding? Transfer molding was developed largely to avoid the disadvantages found which compression molding. • Transfer molding can make intricate or quit

Explain Degree of Freedom - Jig and Fixture The complete location of components inside a jig or fixtures can be understood with the help of figure. The work piece is a

Find distance of which wagon will travel before coming rest: A train of wagons is first pulled on level track from A to B and then up a 5 percent upgrade as shown in the figur

Define the Side Rake Angle? It measured the slope of top surface of the tool to the side in the direction perpendicular to longitudinal axis it also guides the direction of chi

Q. Use of high temperature materials in Furnaces? Often, furnace tubing and refractory protected membrane walls are fabricated from plain carbon steel with a minimum of 0.25% c

Force required to start the roller: A roller shown in the figure given below is of mass 150Kg. What force T is required to start the roller over block A ? Sol.: Let

Type of strain: There are basically four type of strain 1. Tensile strain 2. Compressive strain 3. Volumetric strain 4. Shear strain

CAPP for Forming Processes Sheet metal parts are produced from flat sheets on presses using special metal forming dies. Process planning for sheet metal parts involves complex

Copper-Nickel Alloys Complete solubility arises between nickel and copper. All alloys have same microstructure and may be cold or hot worked. Cupro-nickel also termed as Ge