Connected rod - part of combustion engine, Mechanical Engineering

Connected Rod:

It is attached to piston at its small end by means of gudgeon pin. The big end bearing is connected to crank pin. It is made up of forged steel.



Posted Date: 10/20/2012 3:57:43 AM | Location : United States

Related Discussions:- Connected rod - part of combustion engine, Assignment Help, Ask Question on Connected rod - part of combustion engine, Get Answer, Expert's Help, Connected rod - part of combustion engine Discussions

Write discussion on Connected rod - part of combustion engine
Your posts are moderated
Related Questions
Eccentricity : This is distance between the axis of rotation and CG of mass. Unbalance : This is the product of mass and eccentricity. Balancing : This is

Track Renewal: Need for Track Renewal Normal maintenance is able to keep up the track standards only to a limited extent. The track gets overaged or the speeds and tr

Determine the moment of resistance of the beam: A circular beam of diameter 100 mm is subjected to bending. The maximum bending stress is restricted to 50 N/mm 2 . Determine t

A simply supported beam ABC with supports at A and B , 6m apart and with an overhang BC 2 metres long takes uniformly distributed load of 1.5 KN/metre length over the entair length

Pneumatic system is a system that uses air to power something. For example, have you seen the tube systems at bank drive-up tellers? Air is used to drive the tubes back and forth f

Interpoles or commutating poles Interpoles are ?xed to the frame in among main poles. They are used for sparkless commutation, i.e, to improve commutation.

Determine maximum stress and modulus of elasticity:  A composite of glass fibres and epoxy has all of fibres laid along the length and is needed to carry a stress of 12 MPa. T

Position of centre of gravity of the frustrum of a cone: situate the position of C. G. of the frustrum of a cone with height H = 12 cm and with  diameter 8 cm and 12 cm at top

If Either Wheel is Wobbling Causes of Problem Remedy Excessive wheel bearing play Distorted rim Improperly

Mounting Systems For The  Welding Head Submerged arc welding head may be mounted by one of the following three methods. a. Fixed type b. Carriage mounted type c. Boom mounted ty