Compute model on simulate the tossing of thee four coins, Mechanical Engineering

Four (04) coins are tossed simultaneously (ie at the same time) and results in either a HEADS or a TAILS in each coin. Develop a simple computer model on MS EXCEL to simulate the tossing of thee four coins 100,000 times and show that the probability of each possible event (ie a HEADS, HEADS, HEADS AND HEADS, a TAILS, TAILS, TAILS and TAILS in all four coins or ANY OTHER POSSIBLE COMBINATION (ie HEADS, HEADS, HEADS and TAILS etc)) approaches the theoretical probability as the number of tosses increase.

Posted Date: 3/25/2013 1:00:45 AM | Location : United States







Related Discussions:- Compute model on simulate the tossing of thee four coins, Assignment Help, Ask Question on Compute model on simulate the tossing of thee four coins, Get Answer, Expert's Help, Compute model on simulate the tossing of thee four coins Discussions

Write discussion on Compute model on simulate the tossing of thee four coins
Your posts are moderated
Related Questions
Goods Market and the IS Curve The IS curve shows the combinations of interest rates and levels of output such that planned spending equals income. In order to derive the IS cur

Q. Explain working of Tubesheets? The tube and tube pitch selected shall be approved by WorleyParsons Canada. The preferred tube pitch shall be a minimum of 1.3 x tube OD and

Q. Bolt Stress to Seat the Gasket? The required bolt stress to seat the gasket can be calculated, using the recommended gasket seating stress provided by the manufacturer in ac

Prove the parallelogram law of forces: Assume that the two forces P and Q act at a point ' O ' as shown in figure given below. The force P can be represented in magnitud

how we made parts of engine

Disk requests come in to the disk driver for cylinders 10, 22, 20, 2, 40, 6, and 38, in that order. A seek takes 6 mes per cylinder moved. How much seek time is needed for (a) F

Problem:   The following machine component is loaded as shown.  It is fabricated from Al 6061-T6.   Determine the analytical solution to this problem and compare result

The Ordinate Dimension Command We can use The Ordinate command to annotate co-ordinate points with X or Y values. This might be useful for setting-out on site plans.

As shown in the figure, the jet transport B is flying north with a velocity vB = 600 km/h when a smaller aircraft A passes underneath the transport headed in the 60 degree directio

Discover the maximum torque: Discover the maximum torque that may be transmitted by the shaft of 400 mm diameter, if the shear stress is not to exceed 50 N/mm 2 . Solution