Compressive strain, Mechanical Engineering

Compressive Strain:

When the compressive load acts on body then there will be an increase in cross sectional area and decrease in length of body. The ratio of reduction in length to original length is called as compressive strain.

ec  =  δL/L

1501_Compressive Strain.png

Posted Date: 10/20/2012 7:37:55 AM | Location : United States







Related Discussions:- Compressive strain, Assignment Help, Ask Question on Compressive strain, Get Answer, Expert's Help, Compressive strain Discussions

Write discussion on Compressive strain
Your posts are moderated
Related Questions
Torque Transmission : The clutch should be able to transmit the maximum torque of the engine under all conditions. It is usually designed to transmit 125 to 150 percent of the max

Flash Butt Welding-Flashing The phenomenon of flashing is of extreme importance in achieving satisfactory welds. Flashing can begin only after a molten bridge has been formed s

Organisation set-up: The civil engineering department of the Railways is responsible for the maintenance of railway lines. The maintenance organisation consists of Chief Engi

(a) What is the importance of safety at workshop? (b) What problems may arise, if we do not take safety precautions in the workshop?

CAUSES AND REMEDIES OF MOTORCYCLE PROBLEMS  If Engine Overheats Causes of Problem Remedy   Incorrect spark plug make/model

CLASSIFIC A TIO N: 1.     In accordance to number of strokes per cycle: (a) Two stroke          (b) Four stroke. 2.     In accordance to the fuel being used: (a)

Normal 0 false false false EN-IN X-NONE X-NONE MicrosoftInternetExplorer4

Describe Inversion and Mechanism. Illustrate in detail all inversions of 4-Bar chain Mechanism. (a) Explain all the types of constrained motion with examples. (b) Explain in

Maximum shear stress and angle of twist: Torques are applied on the shaft as illustrated in Figure. Discover in which portion of the shaft, maximum shear stress & angle of twi

Derive mathematical equation for the time response of a first order system subjected to ramp input. Draw the response curve and determine steady state error. Give some examples of