cold extrution, Mechanical Engineering

short notes with daigram
Posted Date: 5/2/2015 1:45:29 PM | Location : Japan

Related Discussions:- cold extrution, Assignment Help, Ask Question on cold extrution, Get Answer, Expert's Help, cold extrution Discussions

Write discussion on cold extrution
Your posts are moderated
Related Questions
What is Subsetting Subsetting : Vendors selected and implemented only portions of the whole of IGES, thus making exchange between two systems impossible without  prior agreemen

An aircraft moving with speed of 1200 Km/hr, uses simple air refrigeration cycle for air conditioning. The ambient temperature and pressure are 0.35 bar and - 10 o C respectively.

There are various methods of producing components from the plastics materials which are supplied in the granular, power and other forms. Various plastics molding processes discu

Third Gear Position: When gear M3 on the main shaft is in mesh with gear C3 on the counter shaft then this is known as third gear position. The fixed gear M3 rotates with mai

Seawater is boiled in a 5 liter kettle to produce drinking water.  In class we solved the steady-state version of this problem.  Here you are asked to consider the transient period

Chisel: Chisels are used in the combination of hammer to remove metals. A set of chisels is shown in Figure. Figure: Chisel

Steam engines: Steam engine is heat engine which converts heat energy to mechanical energy. The pressure energy of steam acts on piston and piston is moved to and fro in a cyl

Determine the dead load: A 250 mm diameter sewer is placed in a 2.75 m deep rectangular trench that is 0.65 m wide. This trench is backfilled with saturated clay having a unit

Q. Illustrate Clay content test? Under this test, the clay content is measured by washing it off the sand sample. The standard dried sand sample (50 gm) is put in a mixing devi