Clipper and clamper circuit, Electrical Engineering

Clipper Circuits:

Clipper circuit have ability to Clipper of portions of the input signals without distorting the remaining part of the alternating wave form.

Clamper network:

clamping network is one that will clamp the signal without distorting the remaining part of the alternating waveform

Clamper network: clamping network is one that will clamp the signal to a different; level of a dc .clamping network must have a capacitor diode and a resistive element, but it can also employ an independent dc supply to introduce an addition phase shift. R and c must choose such that the time constant to large enough to ensure that the voltage across the capacitor does not discharge significant during the interval, the diode is none conducting.

Posted Date: 2/8/2013 2:26:37 AM | Location : United States







Related Discussions:- Clipper and clamper circuit, Assignment Help, Ask Question on Clipper and clamper circuit, Get Answer, Expert's Help, Clipper and clamper circuit Discussions

Write discussion on Clipper and clamper circuit
Your posts are moderated
Related Questions
Elementary Induction Machines In the discussion that followed Equation, the third possiblemethod of producing constant torque was to cause the mmf axes of stator and rotor to r

Add Register and Carry with Accumulator The contents  of register R and the  carry flag are added to the  contents of the  accumulator  and result of  addition  is also  sto

Q. Three waveforms seen on an oscilloscope are shown in Figure. If the horizontal scale is set to 50 ms per division (500 ms for the entire screen width), and the vertical scale is

Q. Describe small signal FET.What are its characteristics? Small signal FET is the FETs used for amplification. The linear characteristic of FET is used for this purpose The in

What are the different types of methods used for data transmission? The data transmission among two points involves unidirectional or bi-directional transmission of meaningful

Power Distribution: - The Energy Conservation Act, 2001, gives the legal framework, institutional arrangement and a regulatory mechanism at the Central and State level to emba

Q. Illustrate Transformer coupling? In this method the primary winding of the transformer acts as a collector load and the secondary winding transfers the a.c. output signal di

Q. Resultant air-gap flux of induction machine? The resultant air-gap flux is produced by the combined mmfs of the stator and rotor currents. For the sake of conceptual and ana

Find the power supplied by the voltage source and the power absorbed by the 24 Ω resistor (R3) in the circuit shown below:   Determine the voltage V2 in the circuit shown.

Q. Show how a 16-to-1 multiplexer can be used to implement the logic function described by the following truth table.