Clearance volume, Mechanical Engineering

Assignment Help:

Clearance Volume (VC) : The nominal volume of the combustion chamber above the piston when it is at the top dead centre is the clearance volume. It is designated as VC and expressed in cubic centimeter (cc).

 


Related Discussions:- Clearance volume

Determine the response of the system, A force F(t) is suddenly applied to a...

A force F(t) is suddenly applied to a mass m which is supported by a spring with a constant stiffness ‘K'. After a short period of time T, the force is suddenly removed. In the mea

Mechanics of solids, What is Principle of superposition (Uniform cross-sect...

What is Principle of superposition (Uniform cross-section s/t multiple loads)

Calculate the whole reaction at block, Calculate the whole reaction at bloc...

Calculate the whole reaction at block: A bar weighing 1 kg/m is bent at right angles into segments 0.60 m and 0.30 m long. It takes the position illustrated in Figure, while t

Evaluate frequency of oscillation, (a) A spring mass system has a period 0....

(a) A spring mass system has a period 0.25 sec. What will be the new period if spring constant is increased by 50% ? (b) A vibratory system in a vehicle is to be prepared with t

Explain about hardness testing, Q. Explain about Hardness testing? When...

Q. Explain about Hardness testing? When indicated on equipment or vessel data sheets, hardness testing shall be performed as follows: a) Perform hardness tests at or near th

Equivalent force system - mechanics, Equivalen t force System: An equ...

Equivalen t force System: An equivalent system for the given system of coplanar forces is the combination of force passing through given point and moment about that point. Th

E=mc2, why this great equation does not apply(involved) in nuclear reaction...

why this great equation does not apply(involved) in nuclear reaction ?

Performance criteria-aspects of scheduling , Performance Criteria This ...

Performance Criteria This is assumed that an FMS is the part of a superior production process. Consequently the performance of the FMS is not a major goal but imply to attain c

Find out ratio of upper end area to lower end area of bar, Find out ratio o...

Find out ratio of  upper end area to lower end area  of bar of uniform strength Sol : The figure given to us shows a bar subjected to external tensile load P. If bar had be

Types of friction, Types of Friction There are basically two types of f...

Types of Friction There are basically two types of friction, (a) Dry Friction    ( b ) Fluid Friction Dry Friction: Dry friction (also called as coulomb friction man

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd