Classification of welding based on mode of energy transfer , Mechanical Engineering

Classification of welding Based on Mode of Energy Transfer

Energy is converted from one form to another. Any form of energy can be converted to heat energy, which can be used for welding.

1.  Electrical energy converted to heat energy - Arc, Resistance welding.

2.  Mechanical energy to heat - Friction welding.

3.  Chemical energy to heat - Gas welding, Explosive welding.

4.  Light energy to heat - LASER welding.

5.  Sound energy to heat - Ultrasonic Welding.

 

 

 

 

Posted Date: 9/13/2012 3:14:50 AM | Location : United States







Related Discussions:- Classification of welding based on mode of energy transfer , Assignment Help, Ask Question on Classification of welding based on mode of energy transfer , Get Answer, Expert's Help, Classification of welding based on mode of energy transfer Discussions

Write discussion on Classification of welding based on mode of energy transfer
Your posts are moderated
Related Questions
Q. Can you explain about Fuel Oil and Dextrin? Fuel Oil : It improves the mould ability of sand. Iron Oxide: It develops hot strength. Dextrin: It increases air sett

A bank has only one typist since the typing work varies in length (Number of pages to be typed). The typing rate is randomly distributed approximating a Poisson Distribution with m

Leakage flux : The flux that links the coil only partially passes through the core does not link the coil as the moving or rotating device is called leakage flux.

What is the magnitude of frictional force after perfect rolling begins and why? solution) After pure rolling begins,frictional force is 0. This is because the velocity of he c

Ratio of applied stress and yield stress: What should be the ratio of applied stress, s, to yield stress s Y in a large thin plate so that plastic spread along lint of crack

What are the basic components of an automobile ? Explain them briefly. Show a schematic diagram showing the layout of the transmission system of a rear wheel driven automobile.

1- Explain the rationale of using a small WD to improve resolution. 2- In a tungsten SEM , Why does a high accelerating voltage provide the potential for higher resolution?  Why

Tempering and Stabilization: Tempering of tool steel in heat treatment is again a significant step. The quenching of such steels reasons the existence of untempered martensit

A square column 410 x 410 mm (along with 4 No. 16 mm bars) carries a dead load of 1020 kN and an imposed load of 410 kN. The foundation soil has a safe bearing capacity of 200 kPa.

Q. Air-Gas Cross-Limiting and Air-Gas Ratio Control? The Steam Generator firing demand signal is directed to two discrete signal selectors. A low signal selector ensures that