Classification of arc welding power sources, Mechanical Engineering

CLASSIFICATION OF ARC WELDING POWER SOURCES

As we have know, different  welding processes require different operating conditions & the power sources are also necessarily different. Therefore, a simplest classification o power sources is according to the processes. But there are also some common aspects to these power sources. Based on these common aspects we can classify these arc welding power sources according to

 

  • 1. Output characteristics
  • 2. Nature of current output
  • 3. Construction
Posted Date: 9/14/2012 1:48:52 AM | Location : United States







Related Discussions:- Classification of arc welding power sources, Assignment Help, Ask Question on Classification of arc welding power sources, Get Answer, Expert's Help, Classification of arc welding power sources Discussions

Write discussion on Classification of arc welding power sources
Your posts are moderated
Related Questions
Q. Explain about Burner Management System? The Vendor shall provide a stand alone Burner Management System that is NFPA approved. Provision shall be made for communication wit

Thermodynamic process - Thermodynamics: Thermodynamic system undergoes changes because of the energy and mass interactions. Thermodynamic state of system changes because of th


Convert the following readings of pressure to KPa absolute, assuming that the barometer reads 760mm Hg: (a) 100 psig, (b) 8in. Hg vacuum, and (c) 76in Hg gage.

Heat Treatment of Tool Steels This treatment in case of tool steels in a significant step before actually employing the tool. Most properties are attained after heat treatment

A gear drive is needed to transmit a maximum power of 22.5KW. The velocity ratio is 1:2 and r.p.m. of the pinion is 200. The centre distance between the shafts can be taken as 600m

Find out the centroid of an area of a semicircle: Find out the centroid of an area of a semicircle illustrated in Figure. Solution You shall note that it is not p

Engine Oil Replacement and Top-up :   The engine oil has to be changed at a periodic interval because after some point of time it loses its viscosity and cooling, anti rust, and se

State required Features of Fourier Law. What are the factors on which co-efficient of thermal conductivity (K) depends upon ? Write the unit of K.

What is Metal Cutting Tool? A cutting tool (or cutter) is any tool which is used to remove material from the work piece by means of shear deformation. Cutting may be completed