civil engineering structures, Other Engineering

I need help for my project report plz.<>
Precast concrete panels manufactured in factory environments and rapidly cured using steam are being used for the walls of shallow foundations e.g. one storey basement car parks below mixed use developments. A qualitative
assessment of the precast concrete, which is cast against impermeable steel shutters, says that the durability of the precast concrete should be greater than its site cast counterpart. However, little or no information is published in
design guides on the durability of precast concrete to resist the ingress of chloride salts in solution, as would typically
be found in coastal environments.
The aim of the project is to therefore carry out a series of small scale tests in the laboratory to determine the effect of a range of concrete casting conditions on the ingress of chlorides.Ansys software can be used for modeling.Thank you very much
Posted Date: 4/28/2012 10:48:13 AM | Location : United States







Related Discussions:- civil engineering structures, Assignment Help, Ask Question on civil engineering structures, Get Answer, Expert's Help, civil engineering structures Discussions

Write discussion on civil engineering structures
Your posts are moderated
Related Questions
Electrical ice protection systems: Electrical ice protection systems are used on most turbo-props.  Resistance wire heater elements are embedded in rubber and cemented from the


Composites have low shear strengths compared to longitudinal strengths. The ILSS test is a simple 3 point bend test, requiring a small amount of material. A span to depth ratio

#question.what is angle and bearing.

aieee ka course karne ke liye kya karna padega

Q. Explain briefly the Friction welding techniques.                                                      OR       Discuss any two solid state welding methods.

suggestion regarding credit limit. should it be approved or not what should be the amount of


The closed form solutions for ?max and Mmax are given on page 16.1-276 for several axial loads. Figure C-C2.2 summarizes the results for the first benchmark problem and Figure C-C2

INSTALLATION OF PROPELLER The method of installation will depend on the type of propeller, and all instructions detailed in the appropriate AMM should be carefully followed; th