Circuit board packaging, Electrical Engineering

Topics for the projects

1. Power supply design: One source, multiple source.

Project process:

1.  Design(circuit analysis, diagram, list of components).

2.   Hardware execution(circuit board packaging, soldered, standard connections).

 

Posted Date: 3/28/2013 2:31:25 AM | Location : United States







Related Discussions:- Circuit board packaging, Assignment Help, Ask Question on Circuit board packaging, Get Answer, Expert's Help, Circuit board packaging Discussions

Write discussion on Circuit board packaging
Your posts are moderated
Related Questions
Q. The parameters of a BJT are given by α = 0.98, I CBO = 90 nA, and i C = 7.5 mA. Find β, iB, and iE.

Q. Compare MOSFET with  JFET? a. In enhancement and depletion types of MOSFET,the transverse electric field induced across an insulating layer deposited on the semiconductor ma

Q.   Explain the working principle of an electronic voltmeter. Sol. Electronic voltmeter Basic Voltmeter: The addition of a series resistor, or multiplier, converts the

Mould Casting: Plaster Moulding : In this method, the mould is prepared in gypsum or plaster of paris. In practice, the plaster of paris is mixed with tale, asbestos, fibers

Q. Consider the common-source JFET circuit shown in Figure with ?xed bias. Sketch the sinusoidal variations of drain current, drain voltage, and gate voltage superimposed on the di

Simplified operation: Figure: Simple circuit to show the labels of a bipolar transistor. The essential value of a transistor comes from its capability to make use

For an operating point half way up the parallel section and the discharge valve and the discharge fully open, design a proportional only controller which will give closed loop dyna

Direct and Indirect Semiconductors 1) In a common quantitative calculation of band structures, the wave function of a single electron traveling by a perfectly periodic lattice

Q. A current of 65 A is measured with an analog ammeter having a probable error of ±0.5% of full scale of 100 A. Find the maximum probable percentage error in the measurement.

why Direct current flow through semiconductors but alternating current cannot flow?