CCNA, Computer Networking

What is basic purpose of Routers
Posted Date: 2/20/2013 2:15:24 AM | Location : Pakistan







Related Discussions:- CCNA, Assignment Help, Ask Question on CCNA, Get Answer, Expert's Help, CCNA Discussions

Write discussion on CCNA
Your posts are moderated
Related Questions
FCS= Frame Check Sequence CRC (Cyclic Redundancy Check) algorithm runs in switch that known as FCS (Frame Check Sequence)

10Base2 - Thinnet Cable diameter is about 0.64 cm (RG-58) More flexible as well as easier to handle and install than Thicknet "2" represents a maximum segment len

Q. Explain about Twisted-Pair Cable? - Two conductors surrounded by insulating material - One wire utilize to carry signals and other used as a ground reference - Twistin

QUESTION 1 (a) Draw a use-case model for the above system. You must identify all possible actors and use-cases. (b) Assume you are using the Rational Unified Process a

Every input line of the combinational circuit represents an individual element of the string say xi and every output line results in the form of a sorted list. In order to attain t

DEFINITION: Latency = Delay. Because a store and forward switch reads the entire frame before forwarding, a larger frame takes longer than a shorter frame.

What is SAP? Series of interface points that permit other computers to interact with the other layers of network protocol stack is known as SAP.

Quetion: An amplifier increases the peak-to-peak voltage of a signal from 1 V to 20 V. What is the amplifier's gain in dB?

Recognize the command to disable CDP on an interface Ans) Router(config-if)# no cdp enable

Q. Show the Data Encryption Standard? Data Encryption Standard - Bit-level encryption method designed by IBM - Adopted as standard for nonmilitary and nonclassified us