Capacities of machine tools and surface finish, Project Management

Capacities of Machine Tools and Surface Finish

Capacities of Machine Tools:

The dimensional limitations of machine or equipment and their capacities should be considered. Such as lathe size capacity or press capacity of furnace etc.

Surface Finish:

The type of tool machines manufacturing process selected will vary with surface finish requirements. When rough  surface finish is sufficient  single point  cutting tool is used but when smooth surface finish is desired  multipoint cutting tool and costly  operations such  as honing, lapping  and super finishing  are carried out .

Posted Date: 1/11/2013 5:28:33 AM | Location : United States







Related Discussions:- Capacities of machine tools and surface finish, Assignment Help, Ask Question on Capacities of machine tools and surface finish, Get Answer, Expert's Help, Capacities of machine tools and surface finish Discussions

Write discussion on Capacities of machine tools and surface finish
Your posts are moderated
Related Questions
QUESTION While scoping a project, as much information as possible should be gathered about the wants and concerns of sponsors and end-users. What are the useful channels of

Tools and Techniques of Layout Planning - Templates Templates are most commonly employed when preparing layouts. Templates are two dimensional (2D) or block templates consist

think a project of your own and formulate a questionnaire

Tolerance and Surface Finish Design engineers are always blamed of specifying closer tolerances than necessary. It  is obvious that to achieve a tolerance of ± 0.001 mm is mor

P hases of value engineering process I nvestigation phase: This phase investigates the background information, the technical input reports, the field data, the functiona

Kilbridge and Wester Method of line Balancing Kilbridge and Wester propose this method. Here numbers are assigned to each operations describing how many predecessors it has.

Multiplicity of processes available for a job the selection of an appropriate process is not an easy matter. Choosing a process with over capability is as bad as choosing one w

Quality ultimately is calculated in terms of customer satisfaction.) Surveyed before product delivery and after product delivery (and on-going on a periodic basis, using standar

I need a decision matrix- a Grid Analysis (Weighted Scoring Model) to Help Make the North American Plant Location Decision for the RX 330 I need the acual model calculated based

While the industry average ROE is about 15%, average profit margin of 50%, asset efficiency of 10%, and leverage ratio of 3, the ROE for ABC, Inc., using data from January 2011, wa