Calibration and testing of energy meters, Electrical Engineering

Calibration and Testing of Energy Meters and Meter Laboratory

Energy meters form a vital instrument of revenue realization for the distribution utilities. Based on the meter reading and the utilities submit their bills to consumers for realization. Inaccurate/faulty recording might become catastrophic both to consumers and utilities. Therefore, a requirement to ensure a high degree of performance and reliability from the meters has become significant. The meters are tested and calibrated to ensure proper working and in which the accuracy is to be maintained inside permissible limits under IE Rules.

 

Posted Date: 2/6/2013 7:48:49 AM | Location : United States







Related Discussions:- Calibration and testing of energy meters, Assignment Help, Ask Question on Calibration and testing of energy meters, Get Answer, Expert's Help, Calibration and testing of energy meters Discussions

Write discussion on Calibration and testing of energy meters
Your posts are moderated
Related Questions
The Problem Based Learning is an approach to learning prepares the students to engage with challenges similar to real world problems.The VEB3001-Problem Based Learning has been an

Q. A charge variation with time is given in Figure. Draw the corresponding current variation with time.

A squirrel-cage inductionmotor operates at a slip of 0.05 at full load. The rotor current at starting is five times the rotor current at full load. Neglecting stator resistance and

A circular ring of magnetic material has a mean length of 1m and a cross sectional area of .001m^2.A sawcut of 5mm width is made in the ring . calculate the magnetizing current req

With the help of neat sketch T-S diagram illustrate the working of simple air evaporative cooling system used in air craft. With the help of neat diagram and T-S diagram iillust

Q. Find the exponential form of the Fourier series of the periodic signal given in Figure. Also determine the resulting series if T = 2τ .

ie rule for guard wire

Q. Determine the Thevenin resistance viewed from terminals A-B of the circuit of Figure by setting independent sources to be zero and applying a test voltage at terminals A-B.

In this project we will consider the control of a synchronous generator supplying electricity to the grid. We will focus on the problem of frequency stability. The frequency at whi

Q. A 230-V, single-phase, 60-Hz source supplies two loads in parallel. One draws 10 kVA at a lagging power factor of 0.80 and the other draws 6 kWat a lagging power factor of 0.90.