Calculate the voltage gain, low and high break frequencies, Electrical Engineering

Using the BC548B BJT transistor amplifier biasing circuit of Lab 2 build an amplifier with the voltage gain of  |AV| = 30 v/v ± = 10%. Measure all necessary parameters of the amplifier (as per deliverables) for three separate cases: unbypassed resistor Re, fully bypassed resistor Re, and partly bypassed resistor Re.

Deliverables:

a.) Show the proposed amplifier circuit and your hand calculations of the voltage gain, Low and High break frequencies as well as input/output resistance.

b.) Show the amplifier circuit in PSpice that you have used to evaluate the output resistance of your amplifier. 

c.) Show the actual frequency response of your amplifier using NI ELVIS.

Posted Date: 2/21/2013 6:30:21 AM | Location : United States







Related Discussions:- Calculate the voltage gain, low and high break frequencies, Assignment Help, Ask Question on Calculate the voltage gain, low and high break frequencies, Get Answer, Expert's Help, Calculate the voltage gain, low and high break frequencies Discussions

Write discussion on Calculate the voltage gain, low and high break frequencies
Your posts are moderated
Related Questions
Illustrate the working of full wave rectifier using bridge rectifier. How is it different from centre tapped Rectifier ? Illustrate Avalanche and Zener breakdown. Draw & explain

assume that the top of the stack in the program is pointed by the register sp.

Q. A balanced delta-connected load with a per-phase impedance of 30+j10  is connected in parallel with a balanced wye-connected load with a per phase impedance of 40-j10 . This l

Q. Consider a series-carry synchronous counter with T flip-flops shown in Figure in which the AND gates carry forward the transitions of the flip-flops, thereby improving the speed

Q. The magnitude spectrum of a continuous  image is as given below.  a) Sketch the frequency response of the sampled spectrum if   ωs =1.5 ωm along x and 3ωm along  y directions

Q. Use (a) mesh analysis and (b) nodal analysis to determine the current through the 4-resistor of the circuit of Figure.

Explain Lithography. Lithography - This is one of the processes which is carried out throughout manufacture of integrated circuits. Silica oxide (SiO 2 ) layer is thermally

Define Electric current If an electric pressure or voltage is applied across any material there is a tendency for electrons to move in a certain direction. This movement of fre

Explain Series capacitors These are connected in series with the line conductors and are used to reduce the inductive reactance of long transmission lines and hence the voltage

Q. What do you mean by Companding? In order to lower the crest factor of a waveform, so as to produce better performance, a process known as companding is used. It works like a