Calculate the magnitude of the induced field, Physics

A long solenoid has a diameter of 10.4cm. When a current I exists in its windings, a uniform magnetic field of magnitude B=37.7 mT is produced in its interior. By decreasing I, the field is causes to decrease at the rate of 7.23 mT/s. Calculate the magnitude of the induced field (a) 3.75cm and (b) 8.58cm from the axis of the solenoid.

 

Posted Date: 3/22/2013 3:46:16 AM | Location : United States







Related Discussions:- Calculate the magnitude of the induced field, Assignment Help, Ask Question on Calculate the magnitude of the induced field, Get Answer, Expert's Help, Calculate the magnitude of the induced field Discussions

Write discussion on Calculate the magnitude of the induced field
Your posts are moderated
Related Questions
Bug on a Bowling Ball A bug sitting on top of a bowling ball begins to slide o? with negligible friction. Conclude the angle at which the bug leaves the surface. This proble

Determine the Magnitude The cantilevered beam shown below has two force couples acting on it as shown.  The value of C1 in Newtons is given in P25.  Determine the magnitude of

maximum 20 mA current can flow through a zener diode.if zener voltage 6V how much resistance will have to be applied in series with the zener diode for 9V supply? calculate load cu


Lorentz was the first to obtain the equations which relate the space and time coordinate of two frames of reference moving with a constant velocity with reference to each other and

An aereplane has velocity 500m/s with respect to air. Wind blows with velocity 20m/s along north. Then in what direction pilot should be heading so as to go along North-east direct

Properties of laser: Lasers have applications in various disciplines of science and technology. They also find applications in industry, medicine and defence and space science

about beam intersection in gama and alpha beam?

A transparent glass cube, of side 20 cm has a small air bubble. When it is viewed normally from the nearest face it seems to be at 0.05 cm from that face and when it viewed throug

You just need to use numerical methods to find temperature distribution in two or three dimensional plate; cylinder, sphere or you can model heat flow in any geometry with boundary