Calculate the cutting speed, Mechanical Engineering

Calculate the Cutting Speed

Calculate the cutting speed when a workpiece of 100 mm dia is being turned. The spindle speed being 200 rpm.

Solution

Dia of the job D = 100 mm

Spindle speed N = 200 rpm

Cutting speed Vc = π DN /1000 m/min

                         = ( π × 100 × 200 )/1000

                       = 62.85 m/min

Posted Date: 12/24/2012 4:47:28 AM | Location : United States







Related Discussions:- Calculate the cutting speed, Assignment Help, Ask Question on Calculate the cutting speed, Get Answer, Expert's Help, Calculate the cutting speed Discussions

Write discussion on Calculate the cutting speed
Your posts are moderated
Related Questions

The following steps are taken to decarbonise the engine : Remove the exhaust muffler. Disconnect the spark plug. Remove the intake pipe bolt. Loosen the bolt de

The Center Mark Command We can use  Center Mark command to annotate a circle or an arc with a cross at the center.Illustration above shows a center mark added to a circle quick

Plate shift drum stopper bolt and arm comp Shift drum stopper : Ensure that the plate shift drum bolt is tight and in arm shift drum stopper assembly, check stopper arm bolt for to

Properties of Aluminium Alloys: Among the different properties of aluminium alloys given are notable as: (a) Low density as 2.7 gm/cc (b) Elevated electrical and therma

Hydraulic fluid has to pass a dissimilar set of standards than motor oil. Motor oil has tackifiers, lower sulfur content, and other ingredients that could solve harmful to the seal

Slip of belt: Sol:   When the driver pulley rotates, it carries belt, because of a firm grip between its surface and belt. The firm between pulley and belt can be obtained by

Consideration: 1. From above equation, it is clear that centrifugal tension is not dependent of T1 and T2. It depends upon velocity of the belt. For lower belt speed (that is,

properties of moulding sand

Q2.1  Using the stiffness method calculate axial forces and the deflections of the joints of the truss shown in the FIG. The truss was built using 50 mm x 50 mm x 5 mm SHS with  E