Bucket conveyors, Mechanical Engineering

Bucket conveyors are used to moves the granular powdered or liquid materials. The buckets may be mounted on a chain or a belt. The movement may be vertical or flat. The vertical movement may be continuous wherein buckets are hooked in a sequential circular manner or discrete where buckets are hooked for lifting.

Posted Date: 3/25/2013 3:59:25 AM | Location : United States







Related Discussions:- Bucket conveyors, Assignment Help, Ask Question on Bucket conveyors, Get Answer, Expert's Help, Bucket conveyors Discussions

Write discussion on Bucket conveyors
Your posts are moderated
Related Questions
Define the Effect of Feed Increase in feed rate deteriorates surface finish. It is observed that a rate of feed in the range from0.12 to 0.15 mm per revolution has a negligible

Normal 0 false false false EN-US X-NONE X-NONE

Q. Module Assembly Site Preparation? To set a module on the piles installed on project site, the following preparations shall be made: The Designer shall provide design elev

Polyhedra and Euler's Formula The b-rep of a polyhedra that are holomorphic to a sphere are topologically valid if they satisfy the following equations : F - E + V - L = 2 (

Determine the reactions at bea: A cantilever AB, 1.8 m long is fixed at A and carries uniformly distributed load of 20 kN/m over its entire length and a point load of 30 kN at

Voltage: The voltage is the potential difference between two points. The current flows from higher potential to lower potential. Voltage is measured in volts (V). V = IR

Driving mechanism   I). Knurl or Friction Drive :  This has either the upper or lower electrode (or both) driven by a friction wheel on the periphery of the electrode. A co

I am am Mtech student of Machine design and I am willing to join some core companies so is this the right time for learning some software''s if yes which are they...

Figure shows rough sketch of a selected representative critical part of a "Quick Coupler" (of an earth moving equipment) made with cast steel.  You need to perform FEA analysis to

WHATIS CG OF A WIRE BENT IN THE FORM OF A QUARTER ELLIPSE