boundary work assingment, Mechanical Engineering

A system consisting of 2kg of R-134a undergoes a cycle composed of the following processes:
Process 1-2: constant volume from P1= 10 bar, x1=0.6 to saturated vapor.
process 2-3 constant temperature to p3=p1 Q2+3= 228kJ
process 3-1 constant pressure
sketch cycle on p-v and t-v diagrams. determine the net work and the heat transfer for each
Posted Date: 9/12/2012 2:22:40 PM | Location : United States

Related Discussions:- boundary work assingment, Assignment Help, Ask Question on boundary work assingment, Get Answer, Expert's Help, boundary work assingment Discussions

Write discussion on boundary work assingment
Your posts are moderated
Related Questions
Resultant of force system: Resultant is single force that produces the same effect as produced by the number of forces jointly in the system. In equilibrium magnitude of resul

RECTIFIER TYPE POWER SOURCES The next popular power sources are of rectifier type. Three phase transformer (step down) connected to a rectifier to give DC output is the simple

Step s for Solving Problem for Finding Maximum Power: 1. Use formula stress (σ) = force (Maximum Tension)/Area Where;  Area = b.t that is, T max = σ.b.t 2. Unit mass (

A shaft is hinghed by two bearings placed 1.0 m apart. A 600mm diameter pulley is mounted at a distance of 300 mm to the right of left hand bearing and this operates a pulley direc

Normal 0 false false false EN-IN X-NONE X-NONE MicrosoftInternetExplorer4

common formula for first law of thermodynamics #Minimum 100 words accepted#

Find out load lifted by the machine: An effort of 400 N is applied in a lifting machine. The distance moved through effort is 4 m and that by load is 40 cm. If the efficiency

A column of timber section 15cm x 20cm is 6 meter long both side being fixed. If the youngs modulus for timber is 17.5 KN/mm 2 , Evaluate: a) Crippling load and b) Safe load

Features of the Schem:  Features of the scheme are as follows : DIC is the primary registering centre. Registration is voluntary and not compulsory. Two types of

Evaluate the angle - block impends down the plane: What should be value of the angle shown in the figure so that the motion of the 90N block  impends down the plane? The coe