Borides, Mechanical Engineering

Borides

Borides of Mo, W, Cr, Ti and Zr find extensive industrial application. They exhibit extremely high hardness, melting point from 1800 to 3000oC and good chemical resistance. Conversely, their application is, restricted to temperature of 1400oC where they begin to oxidize.

 

 

Posted Date: 2/27/2013 1:50:55 AM | Location : United States







Related Discussions:- Borides, Assignment Help, Ask Question on Borides, Get Answer, Expert's Help, Borides Discussions

Write discussion on Borides
Your posts are moderated
Related Questions

MATERIALS WELDABILITY Electron beam welding has the ability to weld a variety of materials including dissimilar combinations. These can be split into general categories as to t

Compressio n Ignition Engines (or C.I. Engine): It works on the basis of dieses cycle. In diesel engines, energy addition occurs at constant pressure but energy rejection at

Impact Factor on Vessel rigging analysis? Unless otherwise specified by the user, a minimum impact factor of 1.5 shall be applied to the lift weight for designing the lifting d

The differential manometer (shown below) is used to measure the pressure difference between two vessels. Derive the equation for the pressure difference (pA - pB) in terms of the l

Why is back rake angle preferred to be negative for brittle materials?

Pliers: Pliers are used just for gripping or wire cutting and should never be used as substitute for spanners. The following types of plier are used : (a) Side cutting pliers

FRICTION WELDING In this, friction is employed to generate heat b/w two sliding or rotating metal surfaces. This process is usually carried out by placing the pieces to be welded

In general, gear drive is useful for power transmission among two shafts, which are near to each other (at most at 1m distance). In addition, it has maximum efficiency whereas tran

Pier and Well Foundations Pier foundations are used when the loads to be transmitted are heavier than loads those can bc acconlplished by piles. They are essentially bearing i