Blanking, Other Engineering

Blanking involves cutting of the sheet metal along a closed outline in a single step to separate the piece from the surrounding stock. As shown in figure, the path that is cut out is the desired product in the operation and is called the blank. 

Posted Date: 8/3/2012 5:31:59 AM | Location : United States







Related Discussions:- Blanking, Assignment Help, Ask Question on Blanking, Get Answer, Expert's Help, Blanking Discussions

Write discussion on Blanking
Your posts are moderated
Related Questions
Double acting feathering system: To prevent excessive drag in the event of a propeller on engine failure, the double acting propeller as with the single acting propeller requir


The Impact and Post-impact Behaviour of Composites  Many early studies involved doing Charpy tests on small notched samples. This is a destructive test of impact resistance, co

Resistive transducers Linear or rotary potentiometers can be adapted to measure displacement, possibly through mechanical gearing and linkages. The displacement is registered a

Explain block diagrams of digital frequency meter and describe function of each part

Two readings i.e., 1.64m, and 0.73m, were taken during leveling procedure to define the slope of centerline of a bridge at points A, and B. If distance AB = 50m, find the slope of

what will be the methodology to calculate pitching moment damping coefficient of canrad of aircraft

Engineers sometimes add chlorine to pipes to disinfect water. It is desired to achieve four logs of kill. This means that the effluent concentration of microoganisms is 10^-4 times

It consists o a source of x ray, with a number of collimated slits. Crystal under investigation is mounted on a table, and the position of this table can be recorded on vernier sca

Signal conditioning amplifier The primary function of the signal conditioning amplifier is to match the output signal range of the transducer to the input signal range of the a