Binary division , Electrical Engineering

Binary  Division

Similar  to multiplication  division can be seen  multiple  subtractions.  For example  if we have to divide 9 by 4  we can subtract 4 ,2,  times  until is is left  with an number  less than  4, i ,e then 2 will be the  quotient and 1 will be the  remainder. Actually this  concept is used in  microprocessor for  division. Followings  example  shows  a simple  binary  division.

Example:  Divide   1101102 by 1012

Solution  :   divisor         10) 110110 (  1010

                                             101

                                                  111

                                                  101

                                                      100

Important  : multiplication is multiple additions and  division  is multiple sub tractions. And  as we know  that subtraction is  done by  addition  using 2 complement method. So the  division can be  done by  addition. Hence  a single  digital circuit of an adder can perform all these basic  operations of  additions  subtraction  multiplications and division.

Posted Date: 4/3/2013 7:20:09 AM | Location : United States







Related Discussions:- Binary division , Assignment Help, Ask Question on Binary division , Get Answer, Expert's Help, Binary division Discussions

Write discussion on Binary division
Your posts are moderated
Related Questions
Q. What do you mean by Digital Building Blocks? Whereas a continuous change from one value to another is the essential characteristic of an analog signal and continuous-state (

Q. emf produced by windings? The time variation of emf for a single conductor corresponds to the spatial variation of air-gap flux density. By suitable winding design, the harm

Q. In a depletion MOSFET for which V P = 3 V and I DSS = 11mA, the drain current is 3mA when v DS is set at the largest value that will maintain ohmic region operation. Find v G

• Vectors can be represented in terms of basis vectors, a set of vectors that span the vector space • Mostly will use i, j, k to denote a Cartesian right-handed basis set • V

Write a short note on RS-232-C. The RS-232 standard is a collection of connection standards among different pieces of equipment. The EIA RS-232 serial communication standard is

Determine the shaft power output: A 6-pole, 50 Hz, 3-phase induction motor running on full load develops a useful torque of 180 Nm when the rotor emf frequency is 2 Hz. Determ

Q. Can you explain Noninverting Amplifier? It is called "noninverting" because there is no sign inversion. A typical circuit is shown in Figure. With a finite op-amp gain Ao,

Querying the GIS: Interfaces which use the querying facility are available with the RDBMS. In the network-mapping environment, these give accurate and reliable information to

Briefly explain single mode and multimode fibres The optical fibres were categorized within two according to the number of modes it passes as: • Single mode fibres • Multi mode

Q. What are the Current relations in common emitter configuration? In a CB configuration Ie is the input current and Ic is the output current. These currents are relayed throug