Bifurcation using simulink, Electrical Engineering

i am implementing a paper "on the chaotic behaviour of buck converter" a want to plot bifurcation diagram by using simulink blocks without using coding is it possible??
Posted Date: 2/4/2013 12:01:29 PM | Location : United States







Related Discussions:- Bifurcation using simulink, Assignment Help, Ask Question on Bifurcation using simulink, Get Answer, Expert's Help, Bifurcation using simulink Discussions

Write discussion on Bifurcation using simulink
Your posts are moderated
Related Questions
Q. Explain Standard set of procedure used in Completing a call? Completing a local telephone call between two subscribers linked to the same telephone switch is accomplished th

Discuss the following points with regard to the Company selecting Jebel Ali Free Zone as its Middle East base.  (a) How is a company likely to enhance its supply chain by using

Q Find the diameter of a circular waveguide that will have a lower cutoff frequency of 10 GHz and also specify its largest usable frequency.

Q . Why CE Configuration is widely used in amplifier circuit? The main utility of a transistor lies in its ability to amplify weak signals. The transistor alone cannot perform

Q. A wire with n = 10 30 electrons/m 3 has an area of cross section A = 1mm 2 and carries a current i = 50 mA. Compute the number of electrons that pass a given point in 1 s, an

singly excited magnetic systems

PID controllers are popularly adopted in a wide range of industrial processes. The objective of this design practical is to study the way this PID controller changes system dynamic

Buffer A buffer  is a logic circuit that  amplifies the current or power.  Basically it is used  change the driving  capability  of a logical  circuit. Therefore  it is  someti

Input Characteristics Transistors  can be  operated in the switching  mode. If  base  current IB  is zero transistor is in  an ON  state  behaves as a switch. If  the base  cur

Calculate the gain and phase response of an FIR digital filter Calculate the gain and phase response of an FIR digital filter as in below Figure with A 0 = 1, A 1 = 2, A 2 =